RT Journal Article
T1 Impact resistance of doped CrA1N PVD coatings correlated with their cutting performance in milling aerospace alloys
A1 Bouzakis, K. D.
A1 Michailidis, N.
A1 Gerardis, S.
A1 Katirtzoglou, G.
A1 Lili, E.
A1 Pappa, M.
A1 Brizuela, M.
A1 Garcia-Luis, A.
A1 Cremer, R.
AB A novel methodology based on analytical and experimental test methods for predicting coated tool efficiency in milling Inconel 718 and Ti6Al4V by coated cemented carbide inserts is introduced. The applied coatings were CrAlN films, containing alternatively Zr or Y dopants. The stress-strain curves and the fatigue critical loads of the applied coatings were determined at various temperatures by nanoindentations and impact tests, respectively, employing various FEM-supported procedures for results evaluation. The milling investigations were conducted at various cutting speeds and feedrates. An insight on the developed stress and temperature fields in the cutting wedge region during the milling process at various cutting conditions was obtained by force measurements and calculations, based on FEM-simulations of the material remoral. These results facilitated the explanation of the coated inserts' cutting performance at various conditions. A sufficient correlation of the coatings' impact resistance at various temperatures with their cutting performance at corresponding cutting speeds was revealed.
SN 1310-4772
YR 2008
FD 2008
LK https://hdl.handle.net/11556/3461
UL https://hdl.handle.net/11556/3461
LA eng
NO Bouzakis , K D , Michailidis , N , Gerardis , S , Katirtzoglou , G , Lili , E , Pappa , M , Brizuela , M , Garcia-Luis , A & Cremer , R 2008 , ' Impact resistance of doped CrA1N PVD coatings correlated with their cutting performance in milling aerospace alloys ' , Journal of the Balkan Tribological Association , vol. 14 , no. 3 , pp. 292-300 .
DS TECNALIA Publications
RD 31 jul 2024