Browsing by Keyword "Spark plasma sintering"
Now showing 1 - 2 of 2
Results Per Page
Sort Options
Item Microstructure Evolution in a Fast and Ultrafast Sintered Non-Equiatomic Al/Cu HEA(2021-05-21) Reverte, Eduardo; Cornide, Juan; Lagos, Miguel A.; Campos, Mónica; Alvaredo, Paula; EXTREMATOne of the attractive characteristics of high entropy alloys (HEAs) is the ability to tailor their composition to obtain specific microstructures and properties by adjusting the stoichiometry to obtain a body-centered cubic (BCC) or face-centered cubic (FCC) structure. Thus, in this work, the target composition of an alloy of the FeCrCoNi family has been modified by adjusting the Al/Cu ratio in order to obtain a BCC crystalline structure. However, processing conditions always play a key role in the final microstructure and, therefore, in this work, the microstructure evolution of FeCrCoNiAl1.8Cu0.5 HEA sintered by different powder metallurgy (PM) techniques has been investigated. The techniques used range from the conventional PM sintering route, that uses high heating rates and sintering times, going through a fast sintering technique such as spark plasma sintering (SPS) to the novel and promising ultrafast sintering technique electrical resistance sintering (ERS). Results show that the increase in the processing time favours the separation of phases and the segregation of elements, which is reflected in a substantial change in the hardness of the alloy. In conclusion, the ERS technique is presented as a very promising consolidation technique for HEA.Item Ti3SiC2-Cf composites by spark plasma sintering:: Processing, microstructure and thermo-mechanical properties(2019-08) Lagos, M.A.; Pellegrini, C.; Agote, I.; Azurmendi, N.; Barcena, J.; Parco, M.; Silvestroni, L.; Zoli, L.; Sciti, D.; EXTREMATMAX phases, and particularly Ti3SiC2, are interesting for high temperature applications. The addition of carbon fibers can be used to reduce the density and to modify the properties of the matrix. This work presents the densification and characterization of Ti3SiC2 based composites with short carbon fibers using a fast and simple fabrication approach: dry mixing and densification by Spark Plasma Sintering. Good densification level was obtained below 1400 °C even with a high amount of fibers. The reaction of the fibers with the matrix is limited thanks to the fast processing time and depends on the amount of fibers in the composite. Bending strength at room temperature, between 437 and 120 MPa, is in the range of conventional CMCs with short fibers and according to the resistance of the matrix and the presence of residual porosity. Thermo-mechanical properties of the composites up to 1500 °C are also presented.