Browsing by Keyword "Pin on disc wear testing"
Now showing 1 - 2 of 2
Results Per Page
Sort Options
Item Magnetron sputtering of Cr(Al)N coatings: Mechanical and tribological study: Mechanical and tribological study(2005-10-01) Brizuela, Marta; García-Luis, A.; Braceras, I.; Onate, J.I.; Sánchez-López, J.C.; Martínez-Martínez, D.; López-Cortés, C.; Fernández, A.; López-Cartes, C.; INGENIERÍA DE SUPERFICIES; TECNOLOGÍAS DE HIDRÓGENO; Tecnalia Research & InnovationCrN coatings produced by magnetron sputtering are routinely deposited on tools and components for machining and forming applications. This paper reports on the effect of additions of aluminium (<15 at.%) on the mechanical and tribological properties of CrN coatings. Aluminium has been incorporated into CrN by co-sputtering of chromium and aluminium in a mixture of argon and nitrogen. Mechanical properties have been evaluated by ultramicroindentation techniques and scratch testing, while tribological tests have been carried out against ball bearing steel and titanium alloy balls by the pin-on-disc method. The thermal stability and oxidation resistance of the coatings have also been examined. A significant increase in hardness, reaching values up to 35 GPa, has been achieved for the CrAlN coatings when compared to CrN coatings. The improvement in tribological properties has also been remarkable, with a decrease in friction coefficient against bearing steel and also a non-adhesive wear mechanism against titanium alloy balls. In addition, the CrAlN coatings exhibited higher thermal stability than pure CrN coatings.Item Tailored synthesis of TiC/a-C nanocomposite tribological coatings(2005-10-25) Martínez-Martínez, D.; López-Cartes, C.; Justo, A.; Fernández, A.; Sánchez-López, J.C.; García-Luis, A.; Brizuela, Marta; Onate, J.I.; TECNOLOGÍAS DE HIDRÓGENO; INGENIERÍA DE SUPERFICIES; Tecnalia Research & InnovationComposite coatings made of nanocrystalline TiC (nc-TiC) particles and amorphous carbon (a-C) have been prepared in a double magnetron sputtering system using graphite and titanium targets under Ar bombardment. Chemical composition and microstructure of coatings were studied by transmission electron microscopy (TEM), electron energy loss spectroscopy (EELS), and x-ray diffraction (XRD) for a set of samples prepared varying the ratio and intensity of power applied to each magnetron. Changes in coatings microstructure, from a quasipolycrystalline TiC to a nanocomposite formed by nanocrystals of TiC embedded in an amorphous matrix of carbon (nc-TiC/a-C), are observed depending on the synthesis conditions. Tribological and mechanical properties of coatings were tested using a pin-on-disk tribometer and an ultramicrohardness indenter, respectively. Coatings with moderate hardness (7-27 GPa), low friction (0.1-0.2), and low wear rates (k similar to 10(-7) mm(3)/N m) were obtained. A percentage between 15% and 30% of TiC is found as an optimum value to get a good compromise between good mechanical and tribological properties. Finally, a mapping of the mechanical and tribological properties of the nc-TiC/a-C system is presented for the synthesis conditions employed