Browsing by Author "Azurmendi, N."
Now showing 1 - 2 of 2
Results Per Page
Sort Options
Item A study of parameter and post-processing effects on surface quality improvement of Binder Jet 3D-printed Invar36 alloy parts(2022-02) Lores, A.; Azurmendi, N.; Agote, I.; Espinosa, E.; García-Blanco, M. B.; EXTREMATBinder Jetting Additive Manufacturing technology, besides its high-productivity manufacturing potential, it also offers a high accuracy fabrication route for less common metal alloys or special purpose applications. In the present work, Binder Jet 3D-printed Invar36 alloy parts’ surface quality improvement is studied. Invar36 is a Fe–Ni alloy which presents near zero coefficient of thermal expansion below its curie temperature (279 °C) and it is widely used for high precision instrumentation in space environment. D90 < 22 µm grade Invar36 powder was used and printing process parameters were optimized following the Taguchi DoE methodology, to reduce sintered parts’ surface roughness. Additional sandblasting and electropolishing operations were performed and part surface roughness was reduced from 5 µm Ra to 1.5 µm Ra. Near surface closed porosity emerged and enlarged during the electropolishing process, leaving a non-homogeneous surface appearance. Consequently, a Hot Isostatic Pressing (HIP) thermal treatment was applied to reduce part overall and near-surface porosity, reaching a relative density of 99.8%. After the sandblasting and electropolishing of HIP-ed parts, surface roughness was further reduced to 1 µm Ra maintaining and homogeneous and clean surface. The results of the study showed that Binder Jet 3D-printed Invar36 parts with low surface roughness can be obtained, getting this process and material closer to future space optics developments.Item Ti3SiC2-Cf composites by spark plasma sintering:: Processing, microstructure and thermo-mechanical properties(2019-08) Lagos, M.A.; Pellegrini, C.; Agote, I.; Azurmendi, N.; Barcena, J.; Parco, M.; Silvestroni, L.; Zoli, L.; Sciti, D.; EXTREMATMAX phases, and particularly Ti3SiC2, are interesting for high temperature applications. The addition of carbon fibers can be used to reduce the density and to modify the properties of the matrix. This work presents the densification and characterization of Ti3SiC2 based composites with short carbon fibers using a fast and simple fabrication approach: dry mixing and densification by Spark Plasma Sintering. Good densification level was obtained below 1400 °C even with a high amount of fibers. The reaction of the fibers with the matrix is limited thanks to the fast processing time and depends on the amount of fibers in the composite. Bending strength at room temperature, between 437 and 120 MPa, is in the range of conventional CMCs with short fibers and according to the resistance of the matrix and the presence of residual porosity. Thermo-mechanical properties of the composites up to 1500 °C are also presented.