TY - Journal Article AU - López de Ipiña, J.M. AU - Hernan, Angel AU - Cenigaonaindia, Xabier AU - Insunza, Mario AU - Florez, Sonia AU - Seddon, Richard AU - Vavouliotis, Antonios AU - Kostopoulos, Vasilios AU - Latko, Paulina AU - Durałek, Paweł AU - Kchit, Nadir TI - Implementation of a safe-by-design approach in the development of new open pilot lines for the manufacture of carbon nanotube-based nano-enabled products PY - 2017 PB - IOP PUBLISHING LTD, DIRAC HOUSE, TEMPLE BACK, BRISTOL BS1 6BE, ENGLAND AB - The project PLATFORM (H2020, GA 646307) aims to develop three new pilot lines (PPLs) for the manufacture of carbon nanotube-based nano-enabled products (buckypapers, treated prepregs, doped veils), for the European aeronautics and automotive industries (a Technology Readiness Level 6 - TRL6 -is expected at the end of the project). The Machinery Directive 2006/42/EC (MD) - transposed into the respective national legislations -is the European regulatory framework for the design and construction of new machinery, as the future PPLs. PPLs are not required to comply with the provisions of the MD until they are put into service - expected in 2020, after project completion - but then, the MD will be fully applicable. In this regulatory context, the project PLATFORM is aligning the design of the PPLs according to the MD requirements, in order to facilitate the CE marking in 2020 (TRL9) and avoid potential economic costs associated with future re-adaptations or modifications needed to ensure compliance with the MD. This paper discusses the methodological approach followed by the project PLATFORM to integrate all the nanosafety aspects in the design of the PPLs, in order to achieve safe designs in conformity with the relevant Essential Health and Safety Requirements (EHSRs) of the MD. Since machinery must be designed and constructed taking into account the results of the risk assessment (RA), this paper describes the systematic and iterative approach for RA and risk reduction followed to eliminate hazards as far practicable and to adequately reduce risks by the implementation of protective measures. This process has been guided by the harmonized standards EN ISO 12100 and EN ISO 14123, taking the relevant phases of life cycle, expected uses and operation modes of the PPLs into account. A specific tool to guide the safe design of the PPLs and facilitate the RA process has also been produced by the project (PLATFORM -SbD toolkit). SN - 1742-6588 UR - http://hdl.handle.net/11556/470 DX - 10.1088/1742-6596/838/1/012018 ER -