%0 Journal Article %A Varela, Sonia %A Mangas, Ángela %A Kotercova, Zuzana %A Briskham, Paul %A Giménez, María %A Muñoz, Carlos %A Molina, Ricardo %A Santos, Maite %T Insertion behavior study of multi-material self-piercing rivet joints by means of finite element simulation %D 2019 * American Institute of Physics Inc. %X Over the last few years, fuel economy improvement has driven the use of efficient multi-material structures in the car industry. The combination of dissimilar materials, such as metal-metal and metal-polymer, is a complex issue that requires the use of different and emerging joining techniques. In this context, self-pierce riveting (SPR) is an extremely suitable technique for joining two or more metal sheets, particularly when other techniques are not applicable. SPR requires short manufacturing times and provides both high strength and high fatigue resistance. Yet, this technique still faces some hurdles, such as joining Ultra High Strength Steels (UHSS) with high strength low ductility aluminum alloys, which can result in rivet cracking or aluminum button tearing. Suitable process parameters, including the rivet size and the die profile, are usually obtained through a physical testing procedure to satisfy the required joint specification. This is both expensive and time consuming. Finite element simulations of SPR are being increasingly used to reduce the number of physical tests and to estimate the tensile strength of the joint. The capability to accurately simulate aluminum to aluminum riveting has been demonstrated in recent studies. However, very few simulation studies have been conducted on the riveting of UHSS to aluminum, mainly because this type of joint is a relatively new customer demand driven by the rapid adoption of mixed material car body structures. New rivet designs have recently been developed for joining UHSS to aluminum, these rivets have increased column strength and increased stiffness to enable piercing through UHSS materials. In this study the insertion behavior of these higher strength rivets has been simulated and numerical analysis has been conducted to investigate the influence of the key process parameters on the joining result. The simulation results were compared to physical experimental results and good correlation was achieved. %@ 0094-243X %K Car industry %K Fuel economy improvement %K Self-pierce riveting %K SPR doi 10.1063/1.5112592 %U http://hdl.handle.net/11556/848 %~ GOEDOC, SUB GOETTINGEN